|
|
|
|
|
|
(CU-OVII) RETROFIT, ADVANCED CONTROL UNIT
|
|
|
Upgrade your existing Autoload or competitor's pneumatic loader with this advanced control. This unit is compatible with all previous generations of Autoload standard and Overfill controls. Just remove the existing control that is held on by one nut and put this in it's place. No wire nuts, no crimp terminals, everything terminates directly to a board mount connector. Works with 120v or 220v solenoids and power supplies.
The advanced control incorporates a clever electronic control that adds features such as:
- Overfilling (add up to 30 seconds of load time after the sensor detects material)
- Audible and Visual alarm if you've run out of material at the source
- Visual indication of operating status
- Optional strobe light to alert operator if in alarm
- Improved control box mounting
- Control one or two material sources from the same hardware
|
|
|
|
|
|
|
|
|
|
(CU-SINGLE CO) CONTROL UNIT
|
|
|
The standard Autoload control uses the signal from the level switch to turn on and off the compressed air at the pick up device.
|
|
|
|
|
|
|
|
|
|
(CU-SINGLEOVII) ADVANCED CONTROL UNIT
|
|
|
The advanced control incorporates a clever electronic control that adds features such as:
- Overfilling (add up to 30 seconds of load time after the sensor detects material)
- Audible and Visual alarm if you've run out of material at the source
- Visual indication of operating status
- Optional strobe light to alert operator if in alarm
- Improved control box mounting
- Control one or two material sources from the same hardware
|
|
|
|
|
|
|
|
|
|
(CU-DOUBLEOVII) ADVANCED CONTROL UNIT
|
|
|
Includes two regulators and soleniods for controling two seperate source materials.
The advanced control incorporates a clever electronic control that adds features such as:
- Overfilling (add up to 30 seconds of load time after the sensor detects material)
- Audible and Visual alarm if you've run out of material at the source
- Visual indication of operating status
- Optional strobe light to alert operator if in alarm
- Improved control box mounting
- Control one or two material sources from the same hardware
|
|
|
|
|
|
|
|
|
|
(CU-DBL CONTR) DOUBLE CONTROLLER
|
|
|
The standard Autoload control uses the signal from the level switch to turn on and off the compressed air at the pick up device. The double adds a 2nd air valve for dual inlet loaders that can be disabled and adjusted separately from the primary inlet.
|
|
|
|
